Features
Stylized ottoman
Wide heavy Gauge links Built-in Articulating Elevated Mid-Ottoman
Geometrically balanced
Geometry used to balance chair operation
Handle/lever activated&gravity operated
Handle/lever used for release only
Direct drive with double locks
Direct Drive with double Over-center-locks
Minimum stackup
Flatter links supporting chair wider base mounting points
Extebded life rivet joints
Acetal and Bronze rivet bushings Nylon stop pin bushings
Standard seat height
Same seat height as non-swivel Rocker
Ball bearing glide joints
Greased full race ball bearing glide joints
One piece glide bracket
Single part supporting glide links
Interchange ablity with omega recliners
Benefits
Strength, durability, and safety
Maximum safety and comfort
consistent and easy operation for any person
ease of operation & comfort
Maximum synchronization of sides. Positive locking of both sides
Greater bending resistance
greater sability and strength
Safety & comfort
Reduced wear and increased durability
Reduced noise
Correct seat height for Swivel Rocker Recliner Rocker
Less friction anf longer life
Consistent geometry, greater strength
One Frame
Comments
Profile shape designed for safety and appearance without pinch points.
Articulating design allows use of wider & higher mid-ottoman for elimination of entrapment areas and for leg support.
Occupant's weight used to balance operatopm omstead of springs.
Therefore, the opening, closing, ottoman firmness, and back balance while reclining vary with the weight of the occupant.
Marking the operation consistent from one person to the next.
Springs are used for locking and the initial start of the opening.
Occupant's weight opens chair, handle/lever only unlocks mechanism.
Slight footrest pressure closes ottoman.
Square drive tube connects to and controls both left & right sides.
Improved weight capacity and durability（250 pound occupant weight）
Mechanism base width is closer to seat width while maintaining sufficient clearance between links to eliminate possibility of interference.
All rivet joints have either acetal（Delrin）or Bronze bushings and acetal spacers to eliminate any steel-to-steel contact No metal-to metal noises when links contact stop pins.
Seat height can be maintained in same frame as zero wall and standard.
Effortless glide motion that dose not deteriorate over the life of the mechanism
A single heavy gauge ribbed part used to support glide links where others use 3 separate parts riveted togrther.
All Recliners are interchangeable in the same frame if the frame is constructed for Rocker and Two-Motor Lift.